| Descriptions
1.Rated Voltage:220V-240V、110V-115V
2.Max.Current:10A
3.Frequency:50-60HZ
4.Max.Power:1.1KW
5.Joint Screw:1″
6.Protection Grade:IP65
7.Starting pressure to choose:1.5bar、2.2bar
8.Coverage:As a completely new device, it can guarantee the
optimum control of electric pumps used in a plumpimg systems.Being
an intelligent mix of hydraulic and electronic engineering,the
control maintains both pressure and flow and controls the
operation of the pump automatically. It needs no pressure
tank as in the traditional systems. There are no plenum chambers
to recharge and no irritating variation in pressure and in
flow at the point of use .No adjustmentor maintenance is required.
It is absolutely dependable,durable and simple to install.
9.Functioning:The starting operation archived,the unit is
programmed to perform all the pump control operations automatically.When
particular operational breakdowns occur, such as water failure,obstruction
of the suction pipe,etc,the unit recognizes the breakdown
and red led Failure lights up,at the same time a stop signal
is sent to the pump to prevent damages caused by its working
in the absence of water.Rectification of the failures that
have caused the blockage,allows the system to be restarted
by pressing the Reset button.
10.Instructions for installation.
|
